![pentair screenlogic will not connect pentair screenlogic will not connect](https://sfwish.com/ebay/pictures/200101/9822_11_PENTAIR0003398A_3.jpg)
If you're upgrading from the older version: I've tried to make the plugin a bit more robust for minor network/serial port interruptions. Hours of super-chlorination remaining is available on the 'System' device. Super-Chlor: There is now an action available to set the chlorinator to 'Super-Chlorinate' (Autelis only). Chlorination Rate: There is now an action available to set the salt cell chlorination rate for both pool and spa (Autelis only).
![pentair screenlogic will not connect pentair screenlogic will not connect](https://i.ytimg.com/vi/BGxmq4mnMgQ/maxresdefault.jpg)
As air temperature is now a state of the 'System' device, the variable will no longer be updated. Air Temperature: The previous version of the plugin reported the system's air temperature to a variable. Any feedback on how well this is (or isn't) working is appreciated. To that end, I've added an additional state to the Intellitouch Panel which is the Temperature Adjusted Salt Level which uses a very basic linear correction in order to reduce some of the fluctuations in reported level. It's always annoyed me that this seems to be a 'known' quirk, but even with temperature data available, no correction is made. Temperature Adjusted Salt Level: Although the salt level is available with the Autelis interface, there's still an issue with the salt levels Pentair measures in the first place in that the measurement is sensitive to temperature. Almost all of this information is only updated on Autelis systems. This reports the salt level (yay!), the air temperature, the chlorination rate of the salt cell for pool and spa, any chlorinator errors, status of the various sensors and a few other things. Intellitouch Panel: There is a new device type called 'System' that represents the Intellitouch Panel and will report many 'general' pool states.
PENTAIR SCREENLOGIC WILL NOT CONNECT UPDATE
Hopefully in a future update I'll try to only update temps for whatever is running. Note, that due to the way that the systems report temperature, both systems will report both temps. Control of the heater mode and set points is carried out through the standard thermostat interface and so the old 'Adjust Set Point' action has been removed. (Heater operation status requires the Autelis interface). These show the temperature of the pool/spa, if it is set to heat or not, what the heat set point is and if it is actively heating.
![pentair screenlogic will not connect pentair screenlogic will not connect](https://user-images.githubusercontent.com/46235745/52173186-e593e100-2733-11e9-81c4-2aff319cdb0c.jpg)
This device will appear in Indigo as a thermostat. For a Pool or Spa that is heated, you can set up a 'Heater' device. Pool and Spa Heat: These are new devices. Pool and Spa: These are now set up as simple auxiliary circuits and will no longer carry the temperature data. Things that were initially set up as a simple on/off (like a light, or waterfall feature) are still set up that way. Auxiliary circuits: These are basically unchanged.